Progress has been made in dribs and drabs this last month. The end is in sight however. The rest of the printed parts have been installed and a lot of the cabling has been completed. There is still a little bit that needs to be done on the extruder but its at the point where its the small finishing off stuff that takes time but doesn’t look like a lot of progress.
Still to arrive is the motor controller board (RAMPS 1.4), Arduino MEGA and the some misc electronics. I’m also still waiting on the couplings to connect the Z motors to the threaded rod.
The aim this next week is to get all the small annoying bits out of the way so that when the new parts finally arrive installing them is all that needs to be done.